Do I need to secure the rudder with some sort of short tether in case it becomes detached from the gudgeon?
I am pretty certain I am being paranoid but I thought I would ask.
JV
My first Sunfish project.
Mostly new hardware, sheeting and paint.
Crafted new rudder and daggerboard from 3/4 mahogany.
I have never sailed a sunfish yet but have sailed a Cyclone.
Hope it is not much harder.
Thankyou for your many helpful replies to my questions.
JV
Thanks to both of you. I wouldn't have worried about it so much but they have different whole spacings. I didn't want to put any unnecessary holes in this boat..
JV
The sunfish that I'm refurbishing didn't have a proper eye strap for the ratchet block so I'm installing one. What is the difference between the two eye straps in the photo.
Which one would be better to use for the ratchet block?
Regards
JVS
I am going to mask and paint a blue strip down the center this weekend.
The underlying coats are semigloss White.
Rustoleum's spray paints have quite a few more choices of blues than their
Marine Topside paint which only has "Navy blue". Am I better off sticking to the marine paint or have...
Perfect weather for painting this week.
Mid 70's with a light breeze and only 50% humidity.
I am using Rustoleum Topside white semigloss on the top and bottom.
I primed it with the Rustoleum marine primer last fall.
Please take a look at my photo of the finish I am getting and tell me if this a...
I used to cut similar washers out of those cheap thin cutting boards but recently they've been manufacturing them with sticky undersides so they don't slide off the counters. I just saw that they make cheap school binders out of the same material. It's a little thicker than milk carton is.
I called Rust-Oleum for some clarification. They basically agreed with Shorefun regarding timing between coats. 7 to 10 days for recoat without sanding. There was no limit between coats if you're willing to sand the surface coat.
I think I will have to put the boat in storage till spring. I am...
The directions (Rustoleum Marine Primer / Topside Paint) is clear regarding the minimum time between recoats. My question is, "May I wait a prolonged time between recoats as long as I prep the surface properly?" My work schedule and the amount of daylight are making it difficult to put on a...
I am using Rustoleum's Marine primer and I am having trouble getting a smooth coat. We are using a foam roller and trying to smooth out the edges with a brush. I live in California and it is 80° today. The primer is drying so fast it's been very difficult getting anything resembling a smooth...
Yep,
That looks like what I did wrong. I had no idea that I couldn't sand it off. I won't make that mistake again.
It didn't have much blush on it but I guess it was just enough to cause the refusal of certain areas.
Thank you all for your help.
Can anybody tell me what might be happening here? I am brushing on two part total boat marina epoxy on a newly built daggerboard. Between coats I have been sanding with 120 grit to bring down any high spots and then wiping it down with acetone. On subsequent coats the epoxy doesn't seem to...
I am going to outfit my trailer with bunks this weekend.
I bought swivel bakets so I can adjust the bunks as flat as possible against the hull.
Are 2X4s wide enough or should I install 2X6s. I will also be adding padding and carpet.
Regards,
JV
That looks good but I already had some total boat slow cure Marine epoxy on hand. How long would you say I need to let it cure before I sand down any uneven areas.
JV
I just finished making a new daggerboard out of mahogany.
Now it is time to epoxy the wood. Should I thin the first coat of epoxy or is that unnecessary?
How much epoxy do I need for each coat?
How many coats should I apply.
JV
I am getting ready to paint my Sunfish. Its an 88 but I really like the look of the blue center stripe on the newer models,
Similar tothe one shown below.
I would like to do a straight copy cat of it. I cannot seem to find a good top down image of the paint scheme anywhere.
Do any of you know...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.