shorefun
Well-Known Member
I had one of the screws that holds the bridle loop to the deck break off.
What it seems is just under the fiberglass is about a 3/16" aluminum plate that is threaded by the self threading screws.
I used a diamond tool on a Dremel to grind out the screw. I misjudged the depth and went too far. In the process I made the hole in the plate too big.
What I decided to try is make an insert. I have a lathe so I got some aluminum scrap and bored a hole in for the 8-32 screw then tapped it 1/4-28. When I tapped it I used the fact the tap has a taper to it and I left a shoulder on the plug. This way the plug will jamb into the threaded hole. I also used tread lock to hold it in the hole. I cut a slot on the top so I used a screwdriver to screw it in place.
From the picture labeled holes you can see the glass area and the aluminum area.
Still waiting warmer weather to fix some small holes in this hull. It is a 96 Peterson built and the more I look the more I find voids that will need to be repaired. The hull has some use on it and it was used at a beach. It apparently was taking on water as there is silicon beads around everything. I did find a small hole in the keel that may be the culprit. It was hidden and looked ok, but when poked with a sharp point it went right through.
My yacht clubs youth program is in need of Fish so I plan on letting them use this one for the program. Figure it is already somewhat beat up.
What it seems is just under the fiberglass is about a 3/16" aluminum plate that is threaded by the self threading screws.
I used a diamond tool on a Dremel to grind out the screw. I misjudged the depth and went too far. In the process I made the hole in the plate too big.
What I decided to try is make an insert. I have a lathe so I got some aluminum scrap and bored a hole in for the 8-32 screw then tapped it 1/4-28. When I tapped it I used the fact the tap has a taper to it and I left a shoulder on the plug. This way the plug will jamb into the threaded hole. I also used tread lock to hold it in the hole. I cut a slot on the top so I used a screwdriver to screw it in place.
From the picture labeled holes you can see the glass area and the aluminum area.
Still waiting warmer weather to fix some small holes in this hull. It is a 96 Peterson built and the more I look the more I find voids that will need to be repaired. The hull has some use on it and it was used at a beach. It apparently was taking on water as there is silicon beads around everything. I did find a small hole in the keel that may be the culprit. It was hidden and looked ok, but when poked with a sharp point it went right through.
My yacht clubs youth program is in need of Fish so I plan on letting them use this one for the program. Figure it is already somewhat beat up.