Includes two radial sails (one ILCA class legal), Rooster hiking strap and mainsheet, dolly, and a top cover. Full rig bottom section available if needed.
Boat was last owned by the Canadian sailing team and was used as a scratching post for mountain lion cubs in British Columbia. Has some...
2001 Full-rig Laser sailboat in solid club racing condition, including all of the following gear:
Pro-rig Vang, cunningham and outhaul are all present.
Comes with Full rig setup, with a class legal, club-race quality sail.
Blades - rudder and daggerboard - are in good condition with usual...
So I am a proud owner of a PSA (Australian) Laser, Hull No. 201xxx. It's a great boat from 2013, it's a winning boat, it's stiff and performs great.
Over the years however, I had the occasional ding and scratch, so would like to repair it.
Problem is... I can't find the same gelcoat colour. I...
I am working on splicing laser rigging for a boat. I want to splice the primary onto the middle block and the upper harken wire block, but I've run into issues. In all of the Brummel lock splicing videos I have seen ( for example), the loop cannot be made around something because to create the...
Hello everyone, it’s been a minute since I last visited this forum and I hope y’all doing well
I remember couple of years ago we were full of leaks/teasers from PSA about brand new full carbon rig + laminated sails
If I remember correct it was the C3/C5 and finally C8 rigs. Though since then...
How does one go about resurfacing the older foam foils?
Recently started a project with an older Laser, the foam foils had been exposed to the elements for years, the rudder is in a fairly good condition given the exposure, but the daggerboard has cracks appearing on the surface.
The leading...
So, have this old training sail that I am about to sell for €150...
Before selling it, I wanted to repair the window decently because it had a bunch of holes sealed with tape / adhesive Dacron. A sailmaker advised that the only way was to replace the entire thing, so I trusted him and let him...
"ILCA is now accepting new builder applications for a limited time ending 4 April 2022."
"...the success of the new builder process and the class since 2019 has resulted in significant additional builder interest."
"ILCA anticipates the current round of provisional approvals will be complete...
Hello everybody, I’m owning laser set up dolly by practic, it’s less than a year old and recently I just noticed something. At the stands where the belt is connected, on the bottom must be 2 screws and nuts from the inside (I can’t find any picture) and here’s my case. I have no clue how it’s...
Hi all. (Unfortunately) Due to this COVID19 all yacht clubs are closed, but sailing isn’t only offshore. And I wanted to separate my rudder from tiller/tiller ext to put everything in blade bag. But I found out my tiller stuck in a rudder (pictures below)
How can I separate them?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.