viktor188924
New Member
I have been noticing that the quality of Laser manufacturing has been going down with every year of production. My boat is only a few months old (it was first used as a charter boat in the 2007 Midwinters East regatta). So was my teammate's boat. With both of ours, if you look into the daggerboard trunk from below, you can see that the lip of the deck hangs down into the trunk, and the joint with the hull is not flush. That's not so bad, but the joint is not square. the hull is turned a few degrees in a certain direction compared to the trunk, so one tack is technically better than the other since the daggerboard is always turned. It is like this on both our boats. Mine is 188924, his is 188920. Any thoughts?