I just assembled my new sunfish racer. The manual says to thread one of the brummel hooks on the bungee through the daggerboard hole, but there are two holes. Only the aft hole is large enough, is that the one I use? Of course, I could just remove the brummel hook and then feed the bungee through the smaller, fore hole. Now this is embarressing, but I'm assuming the straight side of the daggerboard is the aft or trailing side. Is that correct? It's been many years since I've sailed an old sunfish, and no, I'm not planning to race but I got a good deal on a 2010 World's. I've given up even trying to understand the use or rigging of the cunningham and outhall adjuster. I'm going to try without them and hope for the best. Any advice?