Trying to mount an outboard on a double-ended cutter


New Member
Hello all,
Hoping to get some help with this task. I need to mount a 9.9 engine on the back of my 36' union Polaris. Since its a doubled-ended cutter the stern is of course not a flat surface. Would love any advice or tips on this scenario. Below you will see some photos of the stern. Trying to avoid drilling as many new holes as possible. This would only be something temporary until I can fix the engine. But I need to do a buoy run.


  • IMG_4789.jpg
    924.9 KB · Views: 4
  • IMG_4790.jpg
    1 MB · Views: 4