davidlapier
New Member
What size pop-rivets are used to hold gooseneck to mast?
Thanks,
-- David
Thanks,
-- David
Poprivet size for gooseneck
- Thread starter davidlapier
- Start date
bjmoose
Member
David,
The diameter is 3/16"
Personally, I recommend using 316 stainless instead of 18-8 stainless, if your riveter can pull them.
Here's a link to a thread where I wrote about (among other things) replacing mine.
http://www.laserforum.org/boom-reinforcing-sleeve-installation-t6479.html?t=6479
-SteveH
The diameter is 3/16"
Personally, I recommend using 316 stainless instead of 18-8 stainless, if your riveter can pull them.
Here's a link to a thread where I wrote about (among other things) replacing mine.
http://www.laserforum.org/boom-reinforcing-sleeve-installation-t6479.html?t=6479
-SteveH
49208
Tentmaker
Replace the two middle rivets with # 10 machine screws/washer/nuts.