What's new

Painting Laser Blades

Drewsimjr

New Member
I want to re paint my lasers blades but I'm not sure how to go about doing that. Does engine know what paint or what that process would look like overall?
 

Wavedancer

Upside down?
Staff member
Most just use (non-glossy) spray paint; a thin layer two or three times. Afterwards, perhaps (wet)sand with very fine paper (at least 1200) for Olympic glory.
 

gouvernail

Super Opinionated and Always Correct
The super duper oh my it is awesome finish is VC Performance Epoxy.
it takes me about eight hours to do a Centerboard and it lasts until you gouge it with a nail, sail at speed into a rocky bottom, or drop the board over the side of your boat and onto the concrete an hour before the start ( yes I know about that last one )
 
Top