Kevin Pierce
New Member
I purchased a new (to me) Sunfish this weekend and ran accross something new (to me) in the outhaul rig. Looks like what was described in an old post here about getting the outhaul control into the cockpit.
"You get a line with a veerrry long tail, and after it goes thru the cleat, take it all the way fwd, around the gooseneck, and then down thru the halyard fairlead. Then either tie a handle on it, or tie it to your daggerboard so it is always handy." (Beldar Boathead)
Everything looks good to go, except I'm not sure about the "around the gooseneck" instruction. Is it over the gooseneck and in front of the mast? Or just around the part of the gooseneck that's between the mast and the boom?
Kevin
"You get a line with a veerrry long tail, and after it goes thru the cleat, take it all the way fwd, around the gooseneck, and then down thru the halyard fairlead. Then either tie a handle on it, or tie it to your daggerboard so it is always handy." (Beldar Boathead)
Everything looks good to go, except I'm not sure about the "around the gooseneck" instruction. Is it over the gooseneck and in front of the mast? Or just around the part of the gooseneck that's between the mast and the boom?
Kevin