I recently rapaired a small gelcoat chip on the bottom corner of the stern (below the rudder). I repaired the chip with a standard white gelcoate repair kit I obtained from the local boat store. After the putty hardened, I noticed the color is quite a bit off from the stark white hull of the laser (a dark beige). Is there something else that needs to be added on top of the gel coat repair to blend it into the hull, like a paint. Structurally it is fine, but to the eye it is an ugly looking scar.
Was there a better product that I should have used that is designed specifically for lasers?
Thanks.
Was there a better product that I should have used that is designed specifically for lasers?
Thanks.