jimmy said:I would use plain old polyester resin rather than West System. West System is an epoxy resin, your laser was built with polyester. I am not an expert, but I don't believe two mix well.
Andyz said:It also looks like the mast step is designed to move up and down inside the donut as the deck flexes?? Is this true?? It will greatly complicate the repair!!
I’m now not sure how to proceed? I’m thinking that I need to make a waterproof bottom cap for the step and then replace the foam??
Thanks again for the help
Andy
Bradley said:Just as an FYI, the article on hull serial numbers can be found at http://wiki.laserforum.org/index.php?title=Serial_Number