I am finally getting around to repairing an old minifish I came across a while back. I've been bouncing back and forth between this forum and the Yahoo group and have come across a lot of good information (almost too much information).
I'm at a stall on the proper way to repair the hull. How to get from cleaning it to painting it? I'm just looking for some advice on what you all think needs to be done to get this minifish into sailing shape. Any help would be greatly appreciated. Thanks!
It's hard to tell what it needs until it gets a bath.
Start with scrubbing bubbles. When I washed mine, I wet it down, sprayed the scrubbing bubbles on, then wiped with a sponge.
I recommend that before reaching for the ajax or comet.
Most of that stuff in the pictures looks pretty easy to repair. In your last picture, what is that? Who drilled a hole in the bottom of your boat?
That isn't the first time I've heard to use scrubbing bubbles. I'll give that a go. Yea that picture is the bailer hole. I posted it as a close up of the hull's surface. The white paint has obviously chipped away but what is the yellow surface showing through? Is it an old paint job or is that the beginning of the fiberglass?
That isn't the first time I've heard to use scrubbing bubbles. I'll give that a go. Yea that picture is the bailer hole. I posted it as a close up of the hull's surface. The white paint has obviously chipped away but what is the yellow surface showing through? Is it an old paint job or is that the beginning of the fiberglass?