I will get it packaged up and weighed.
Send me your email address and I will
Let you know the shipping fees. I will include all of the standing rigging I have in the package. Asking 300.00 it's only had one season of working. The mast was lowered before Sandy blew me off the stand's
What type of winch do you have?. The bases will vary to some. Mainly for bolt spacing. Measure the width across the toe rail side and then to the cockpit on one side and I will compare them to the ones that are on mine. If they are the same I will send you a message. Thanks, Chris.
Cleveland Ohio, The pulpit is not bent at all the post had a bad weld and broke during removal. It does line up perfectly I have MIG and arc welders just no tig otherwise I would
Have repaired it already. Asking 500.00 as is
No, I don't have any hose's and honestly at the ten year mark I replace them just because of the job they do. I do a little bit of online hunting and find quality hose's at a very good price. Just order in full length and cut to fit it also allows you to customize your install. Hope this helps you.
Hi Mike, sorry for the delay, I have a Flicka 20 in front of that garage and over the winter a tire gave out. I have a new one to pick up tomorrow
And I can get in. I built a 17ft. Bow roof shed to work on it and attached it to the garage to keep it stable. Never did think about getting into it...
The teak for the cooler, could you give me the approximate size of the pieces, I had tape on them with each item and location. The oil let most of them fall off. I have three doors with hinges on them I will select the best one for you.