Supercub, Thanks for your reply. I cut a 6" hole in the deck today to get a peek inside the hull. It was bone dry inside, I grabbed the mast step and felt no physical movement or any soft spots. Even put up the mast and had my Son pull it from side to side, nothing. I guess I'll try to repair...
The gelcoat at the bottom of the mast step is cracked and flaking off, also around the ledge of the mast step. I dont believe water is leaking into the hull yet. Its a 2002 fish. Whats the best way to repair this before it gets any worse. I was thinking about dumping some type of epoxydown there...
I removed the swivel block and clam cleat from my 2002 Fish to replase it with an eye strap and ratchet block. What I found were Three holes holding the swivel block in place plus Two holes from the factory for the original eye stap. What is the best way to seal the Three holes left from the...
I Would like to suspend my SF from the ceiling of my garage for storage this winter. I looked back at earlier posts but could'nt find anything on the subject. Does anyone have any suggestions on how to rig a pulley system that might work for this.
I,m the second owner of an '02 Sunfish. On the foward wall of the cockpit just under the deck there is a 1/8" hole. Is this a vent hole or should it be sealed? Also the previous owner installed a bullseye with swivel base and cam for the mainsheet. I would like to replace this with a #019...
Thanks for the info Alan,
I got the end caps off no problem, but what is the cork inserts for, bouancy? Also how tight should the outhauls be and whats the best knot to use?
Bill Calcutt
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.