I would add one note to this and that is, righting this boat in water where your feet are on solid ground is not the same as in water where your feet are kicking just to keep your head out of water. Practice in water over your head once you have the basics understood. This little note "I have...
I used 8" access ports on mine, a small washer on each side to shim it up, 1/2 plywood about 2" bigger than the hole, 3M 5200 to fill the slight gap and seal/glue the hole tight and SS wood screws to fasten it all together. You can see part of the front one in this picture. I needed the extra...
Mine has a piece of fiberglass strap holding the wood in place so it would not fall, however it was rotted to the point it needed replacing anyways. I am working on refinishing the top on mine as well. I put inspection holes front and back for the express purpose of checking these sort of issues...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.