LooserLu
LooserLu
Hi all,
in a technical discussion with other Laserites about using the Rooster Polilite Mainsheet (7 mm diameter) togehter with the Ronstan/Frederiksen 62100 block someone said, there is much wearing to the Polilite.
I got the 62100 and the Polilite only some weeks ago and they where only few in use since then. So, my experiance with that statement about wearing of the Polilite is also few for me. But aft a little test today I could agree, there is really (a few) wearing to see at the surface of my new Polilite-sheet.
Has someone out there experiance with this aspect? Should I now buy a new block (f.e. the Harken Carbo-Ratched-26..) and throw my quite new 62100 (costs here 74 Euro) to the dump? How long will the (not cheap) Polilite work fine, in use with the 62100?
Thanks for some response.
LooserLu
in a technical discussion with other Laserites about using the Rooster Polilite Mainsheet (7 mm diameter) togehter with the Ronstan/Frederiksen 62100 block someone said, there is much wearing to the Polilite.
I got the 62100 and the Polilite only some weeks ago and they where only few in use since then. So, my experiance with that statement about wearing of the Polilite is also few for me. But aft a little test today I could agree, there is really (a few) wearing to see at the surface of my new Polilite-sheet.
Has someone out there experiance with this aspect? Should I now buy a new block (f.e. the Harken Carbo-Ratched-26..) and throw my quite new 62100 (costs here 74 Euro) to the dump? How long will the (not cheap) Polilite work fine, in use with the 62100?
Thanks for some response.
LooserLu