brockenspectre
Member
Great pic.
And I agree, give your nice blue hull and deck a good soapy wash, then fine wet sand with clean soapy warm water, rinsing as you go, and finally you could use rubbing compound (maybe overkill after wet sanding), then 3M fiberglass restorer and wax. You’ll be amazed by the difference. It is a rare color and a good looking boat, I wouldn’t paint it. I’d put a little thickened epoxy in any visible chips or voids in the mast step. I like West System Six10 (comparable with Thixo) because it’s easy, premeasured and dispensed with a caulk gun. Tape off the area, mix the two parts. I use a gloved finger to line the mast step and fill any voids. Tape a chip brush to a paint stick for reaching deeper into mast step if you need to.
Thanks. What grit sandpaper?