Martin_Cph
DEN 182275
When is it time to unscrew certain hull-fitting and reapply marine sealant/silicone to keep them waterproof? Marine sealant only stays 25-30% flexible the first 2 years – after that it hardens up.
I read that some of you blow compressed air into the hull while soaping it and looking for bubbles. Isn’t that a bit risky as the hull is not built for this kind of pressure? You apply force vectors in new directions?
I am also wooried about damaging the screwhole by cutting a new thread. Maybe I should just leave them in and assume that they are OK?
I read that some of you blow compressed air into the hull while soaping it and looking for bubbles. Isn’t that a bit risky as the hull is not built for this kind of pressure? You apply force vectors in new directions?
I am also wooried about damaging the screwhole by cutting a new thread. Maybe I should just leave them in and assume that they are OK?