Is there a "best practice" configuration for dolly-transporting the boat with the sail and mast on the deck? On windy days I try not to rig the boat until close to or on the water. I put the daggerboard and other gear into the footwell , rolled sail + mast on the deck. Often when I'm pulling the...
The info in your message signature tipped me off to the solution! Pulled out my box of pop rivets and found the 1/8" mandrel to fit perfectly.
This is actually a mast to a Minifish.
I 3D printed a replacement bottom cap for the Sunfish mast however, the fasteners are missing.
Tried measuring with a few drill bits and don't have the exact size. The hole seems to be near 0.07" (1.75mm).
Is there a standard diameter for the fastener pin?
I'll probably try with galvanized...
Agree with the above. It looks like a modified Minfish. I have two of them. You can compare the photos.
https://photos.app.goo.gl/b1HCPPAxDhFRkBEk6
https://photos.app.goo.gl/5HtqDCKUE4rWrZVbA
I just picked up a '74 Minifish last week with a seized bailer. Rather than modifying the boat to fit a plastic bailer, I was pondering the idea of 3D printing a replacement. I figure it wouldn't be anywhere as durable as the aluminum one, but with 3D printed plastic parts being so cheap it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.