Thru Bolting Blocks?

M

mmadge

Member
Before. I do this ,just curious what to do if a Block breaks after it is Thru Bolted.How would you remove it to replace?
 
Un-bolt it.. When thru bolting it, leave enough of the bolt such that you can grab it with pliers while you spin the nut -or- slot the bolt with a dremel wheel or similar cutting device so that you can use a screw driver in the bolt while you spin the nut.

-or-
grind/file/cut the nut off

-or

drill the bolt out
 
You must log in or register to reply here.

Back
Top