Hi all
looking to touch up my good condition, second hand, 2003 hull. I found some interesting chips in the cockpit floor near the drain. I know little about the fiberglass deck construction other than what I’ve gathered from this forum.
On the convex corner that turns down into the drain depression, there’s a 3/8 inch hole in the gel coat. To me this looks like a hole in the bottom of a hard boiled egg... there a small void between the gel coat “shell” and the fiberglass underneath.
I could just put some epoxy in, but thought I’d ask for advice first. Is this normal, or a typical minor problem, or something else? Is the fiberglass separating here?
Thanks!
looking to touch up my good condition, second hand, 2003 hull. I found some interesting chips in the cockpit floor near the drain. I know little about the fiberglass deck construction other than what I’ve gathered from this forum.
On the convex corner that turns down into the drain depression, there’s a 3/8 inch hole in the gel coat. To me this looks like a hole in the bottom of a hard boiled egg... there a small void between the gel coat “shell” and the fiberglass underneath.
I could just put some epoxy in, but thought I’d ask for advice first. Is this normal, or a typical minor problem, or something else? Is the fiberglass separating here?
Thanks!