Mashmaster
Active Member
Today, I got a laser for a deal I couldn't refuse. My plan is to make this a recreation laser for days when I just want to sail around. The hull ID is
PSL691401078 and is old and was sitting in someone's backyard. It needs some work, I am hoping not too much. The cockpit floor seems to be intact (Yay) but in the center of the cockpit floor is a little bit of flex. I am thinking that it might be good to inject resin in the floor to make it more solid. Before it breaks like the previous hull.
There is no bailer, so I need to replace that and all the lines. It has two cleats on the deck that I don't understand why they would be there. I will probably remove those unless there is a reason to keep them.
The most concerning place I saw was the crack in the gel coat at the fore of the dagger board slot. It seems very solid there so I am hoping is can sand that area and marine tex or glass that area.
Any thoughts
PSL691401078 and is old and was sitting in someone's backyard. It needs some work, I am hoping not too much. The cockpit floor seems to be intact (Yay) but in the center of the cockpit floor is a little bit of flex. I am thinking that it might be good to inject resin in the floor to make it more solid. Before it breaks like the previous hull.
There is no bailer, so I need to replace that and all the lines. It has two cleats on the deck that I don't understand why they would be there. I will probably remove those unless there is a reason to keep them.
The most concerning place I saw was the crack in the gel coat at the fore of the dagger board slot. It seems very solid there so I am hoping is can sand that area and marine tex or glass that area.
Any thoughts
Last edited: