Woodwind
Active Member
I’ve tossed around RotoZipping a narrow slot to slip in a full length fiberglass G10 backing plate and then gobbing 5200 in through the slot and old mounting holes, pulling it up tight against the underside of the hull, then redrilling the holes after all is cured.
The last step would be finishing the slot in the deck with Marine Tex and Saran Wrap prior to remounting the handle. The White Marine Tex is almost a perfect match for my deck I had real good luck in refinishing a ding on on the bow you can hardly see it…And the Krylon rattle can of paint I have It’s also almost a perfect match too.
Whaddya’ think?
I’ve sailed the _rap out of this boat and so far all is well except for the bow handle.
It is a blast!!!
The last step would be finishing the slot in the deck with Marine Tex and Saran Wrap prior to remounting the handle. The White Marine Tex is almost a perfect match for my deck I had real good luck in refinishing a ding on on the bow you can hardly see it…And the Krylon rattle can of paint I have It’s also almost a perfect match too.
Whaddya’ think?
I’ve sailed the _rap out of this boat and so far all is well except for the bow handle.
It is a blast!!!