Laser transport on pickup truck rack

Stagalv

New Member
I'm wanting to get ideas on how to transport a Laser on top of pickup truck racks. The racks are located on the forward and aft end of the bed which puts them about 5.5ft apart. So I assume upside down but what do you suggest for lashing it down securely? Any photos available? Thanks!
 
I've seen people do it before. Not much different from standard car roof racks. With 5.5 feet, you have plenty of separation. The only difficulty I can see is you might have to move the center of gravity a bit futher forward to avoid having too much of the boat hanging off the back of truck.

To secure it, I would suggest using some ratcheting straps to secure the boat to the cross bars. You want to get it snug so all the slack is gone, but not so tight that it stress the hull. A definite must is tying the bow to the front bumper. I would tie the stern to the real bumper, too.
 
I was hoping to avoid tying the bow to my front bumper. If it's necessary I'll do it. Another thought I had was to buy a roof rack, at least a one bar rack and mount it forward on my cab to further secure the bow of the boat.
 
The decks of Lasers have a slightly convex shape to them. To support the boat properly, you're going to want some pads/spacers to match the shape of the deck while you travel to prevent stress cracks from appearing. I would only worry about this for longer road trips, however, short trips should be fine.
 
I have two trailers. One is built for ‘the correct side up’ and the other with the deck down.

I’ve used two layers of heating insulation material covered with an old sail. The thickness of the material is enough to spread the load evenly.

image.jpg
image.jpg
 

Attachments

  • B2DB5BA9-B796-4F86-8F2A-BCA7D3FD4391.jpeg
    B2DB5BA9-B796-4F86-8F2A-BCA7D3FD4391.jpeg
    1.3 MB · Views: 134
  • 7F7B9C71-E6F0-4619-A9C3-DD90C270F3D8.jpeg
    7F7B9C71-E6F0-4619-A9C3-DD90C270F3D8.jpeg
    1.3 MB · Views: 144
  • 3367919E-A0E4-4544-8FAE-838B99B81379.jpeg
    3367919E-A0E4-4544-8FAE-838B99B81379.jpeg
    2.3 MB · Views: 155
Here is what I ended up with. Been a few hundred miles with it this way and it seems to work well. I lash it down well trying not to strain the hull much and also use pads to cushion the contact areas.
 

Attachments

  • 20190624_122642.jpg
    20190624_122642.jpg
    2.7 MB · Views: 167

Back
Top