LAWilliams
Active Member
I purchased a 1973? Sunfish yesterday for a parts boat to fill in some areas on our current rebuild. The hull is so bad that I almost blew off the deal until the seller finally admitted that I was the only one to look at the boat and he needed it gone. When the price dropped to a case of beer for hauling it off today I couldn't pass on the deal. I do have a problem as I need to dispose of this hull. It has to weigh 180 plus pounds, was stored right side up full of water, has extensive hull damage and stripped of all rigging except part of the metal bailer and some decent metal trim. What is the best way to cut this hull in half or thirds to dispose of it. (Local landfill will not take anything over 8ft. I have an angle grinder, Saws all, and a jigsaw. Any ideas?