what is a good tiller length my tiller is to me too long it goes about 3 inches into the cockpit restricks me when i am hiking way in the aft of the pit it is a wooden tiller easy to redo when cut and sanded cut it right at the cockpit lip or a bit shorter any help would be welcomed
does any one have plans for a design to a cover i need one and i dont have money but i do have the material and people willing to make it for free ok thanks
Re: Was the sailcloth actually rejected by the Victoria's Secret supplier because it
no sail that is use within hours should look like that crapok and other than that most laser sails do suck spend the big bucks and come to erie and ave the local guy make the sail its alot cheaper and they are...
a. how big is ur door and b. how big is ur room? i mean to get the laser in ur room an then to vaccume!!! i wish i could have that and then boot my mom outa the house hahaha
when you use west you get a blemish from the chem reaction i worked in a boat shop were we build all wooden boats with the west system take a green scotch bright scrubby pad. they come in the thin sheets very cheap put water in a bucket and then soak the spot and the scrubby "sand" wipe the...
ok this sounds really stupid but i am a 17 year old laser sailor no money right? ok so what i use when i have scratches or dings i use if u can believe it, Jb weld, waterproof no shrink hard and sandable not to great for huge areas but it is great for them dings and scrapes:confused: beleive it...
ok im sorry but going mid teens lower twenties in a laser just scares me well my laser would break in half but thats cause its the old geezer kind but that would be wicked awsome..
i had the vibration speed and then i launched off of a wave in lake erie and when i was outa the water i just fliped over and crashed the fastest ive gone in a sailboat was 14.5 i was on a home made raceing cat but i can do 80 on my jet boat.. sucked for my cousin when we were tubing... ha i...
can i put an inspection port on the starboard side of the cockpit right by the block where it is slanted i have likea 4 inch plate that i want to put there is there anyt supports right there? :confused::confused::confused: please email me at [email protected]
i wish i knew what 70 felt like again its snowing in erie and its terrible i got my poor laser all covered in plasic sitting on her trailer waiting for the snow to stop so i can get the cars out the garage and my baby back in hahhaa i hate snow
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.