Search results

  1. Ceebee2

    Laser drainage process

    Correct
  2. Ceebee2

    Trailex SUT 220

    I did say for new trailers. Trailers built before the date that the new rules came in can still be used with a trailer board mounted on boat transom
  3. Ceebee2

    Trailex SUT 220

    I don’t believe Trailer board attached to gudgeons is legal in Europe for new trailers. They have number plate mounted on sliding extension bars as part of trailer which you extend to be behind any load on the trailer
  4. Ceebee2

    LP no longer an approved builder-- why?

    European Laser Class, ILCA and LaserPerformance Announcements - Optimist, Open Bic, Youth & Olympic Sailing Blog EurILCA not happy with ILCA action
  5. Ceebee2

    LP no longer an approved builder-- why?

    Class Association statement does not say they are doing anything that conflicts with the construction manual. What it says is that LPE have not allowed inspections to check that they are complying
  6. Ceebee2

    LP no longer an approved builder-- why?

    Will be interesting to know what any new approved European builder can market the boat as. Do not LPE hold the European trademark “Laser”. Are we about to become the International Torch Association?
  7. Ceebee2

    Laser Sailing in London

    In the past I have been a member of King George, Fishers Green to the North of London and Island Barn Sailing Club in the South West of London. Not Sure how many Lasers are Sailed Regularly at any of those Clubs. Fishers Green and Island Barn had regular Solo fleet Racing and certainly had...
  8. Ceebee2

    Laser Sailing in London

    I think you are very unlikely to get any information from the UK Laser Class Website unless prepared to pay to join. I am a Brit living in Thailand and have attempted to find information from there in the past when looking to get a Laser. Couldn’t access the forum, second hand boat list or even...
  9. Ceebee2

    Interesting reading about a composite lower mast for the Radial

    What I would like to know is how it gets an authorised for use performance sailcraft sticker and a laser trademark sticker when there has been no proposal put forward by the class association
  10. Ceebee2

    Closed starting line

    To me that is wrong. If the time keeper is only using the fact that boat is crossing line as proof they are finishing then the job is not being done properly. When I have been race officer in the past, procedure was for boats to always go through the line on upwind leg and boat numbers logged...
  11. Ceebee2

    What Is This?

    Also looking again don’t bend top bracket to 90 degrees, just similar angle to bottom
  12. Ceebee2

    What Is This?

    And burgee bracket not burger bracket. Don’t really want to hang your lunch from top of mast!
  13. Ceebee2

    What Is This?

    That should read vang tang not bang tang. I hate predictive text
  14. Ceebee2

    What Is This?

    Undo the line from the burgee bracket at the front, feed through the fairlead at the back and tie end to the loop at top of sail. Not sure if haliard should run inside sleeve of sail, would think it might get restricted that way. Hoist sail using haliard and tie end off possibly around...
  15. Ceebee2

    Another autobailer question

    Are you really intending to have a 5 year old sail a Laser? I would think even with 4.7 rig it would be totally unmanageable. Is it actually a Laser. Or is it a Laser Pico? This site is all about the Laser Dinghy (4m long) with standard, radial, or 4.7 rigs. All answers so far relate to...
  16. Ceebee2

    Mast rivet size

    Just a question. Are you end for ending the top section or bottom section? Bent masts are usually the top section. All the comments you are receiving relate to bottom section (gooseneck etc) if you are inverting because to prevent bend as appose to corrosion around vang tang & gooseneck the...
  17. Ceebee2

    Is injecting foam in mast & boom for buoyancy a good idea?

    Are you talking about a laser or a Laser 2
  18. Ceebee2

    Centreboard Friction Pad - New or Old Design?

    I find this very confusing and think I must have something wrong with my set up. I have never had trouble with board staying up. My problem is board always comes up several inches when beating. I don't get how the brake can actually do anything because with the bungee pulling the top of the...
  19. Ceebee2

    Centreboard Friction Pad - New or Old Design?

    Is that class legal? I was under the impression the new pad had to be fitted to the existing mounting point. I do find it does not work when fitted like that but thought I was not allowed to move it
Top