rolan
New Member
I 3D printed a replacement bottom cap for the Sunfish mast however, the fasteners are missing.
Tried measuring with a few drill bits and don't have the exact size. The hole seems to be near 0.07" (1.75mm).
Is there a standard diameter for the fastener pin?
I'll probably try with galvanized brads or maybe a dab of 3M 4200.
Tried measuring with a few drill bits and don't have the exact size. The hole seems to be near 0.07" (1.75mm).
Is there a standard diameter for the fastener pin?
I'll probably try with galvanized brads or maybe a dab of 3M 4200.
Last edited: