Recent content by SpecialK

  1. S

    Here I go

    try some surf wax. i never slip on my surfboard when im wearing my wet suit as long as i have my board properly waxed
  2. S

    My project

    also, the last pic is to show the setup I was using to get as much water out of it as fast as possible and that heater helped a ton
  3. S

    My project

    Got this boat for free and I know it's going to take a lot of work but I'm up to the task. It is currently on a diet and the real work will begin when most of the water weight has been lost. I'm pretty sure it was just sitting in a lady's back yard for a good number of years.
  4. S

    Use holesaw for inspection port?

    I used a hole saw on what I believe to be a boat from the 50's. I just taped the entire area and it came out very clean
  5. S

    inspection port placement

    I'm in the process of drying out a boat that is a good bit over weight. I put an inspection port behind the splash rail and am planning on putting one towards the bow. My question is, would it be a problem if i were to install another in the cockpit but cut in to the wall closer to the transom?
  6. S

    Newbie's Free Sunfish...

    I'm also working on a boat and found this link http://www.windline.net/how_to.htm in another thread. So far it has been very helpful

Back
Top