Recent content by sosopix

  1. S

    bow repair

    It's a rubber trim.
  2. S

    bow repair

    Wow. I was impatient and started the repair before I saw either of your posts. I may have to repair again in a couple of seasons, but for now I sanded back a bit more and applied fiberglass. Guess I'll see how that works.
  3. S

    bow repair

    So I figured out why the sunfish was getting so much water when I sailed. Huge cracking on underside of bow. Question, do i need to keep sanding or have I gone far enough? The very front seems to be in good enough shape. Or do I need to sand it out and remove it? And do I just put new fiberglass...
  4. S

    Sunfish dolly

    See a used laser dolly for sale here at half the price of a new one - would this work for a sunfish too?
  5. S

    Traveler/bridle preference?

    Is the mini block class legal? I have one now on my rope bridle.
  6. S

    Traveler/bridle preference?

    Re: traveller preference? thanks, that makes sense.
  7. S

    Traveler/bridle preference?

    I am getting ready to replace my old rope traveller with a wire one, I think both the plain wire and the one with the loop are class legal. Does anyone have a preference for one or the other, and why? thanks, Sue
  8. S

    Options for a soggy fish.

    Try the first option. I did that with my boat last winter, with just two inspection ports, one up near the splashguard and one behind the cockpit. Like yours, I'm not sure what it weighed, but since two of us had trouble carrying it, 300 sounds about right. It's amazing how much lighter it is...
  9. S

    Taco trim

    Does anyone know which size/type of Taco trim works best when replacing the aluminum rubrail trim?
  10. S

    fiberglass repair on hull

    thanks Wayne. the video also talks about "patch booster" for thinning gelcoat and "dry guide" or "dry glide" for help in sanding. any idea where they have this? I've tried checking on the internet, but no luck on the patch booster, and since I don't know if it's glide or guide - no luck there...
  11. S

    fiberglass repair on hull

    thanks Wayne, that makes perfect sense and if all else fails I can try the inspection port, but I am trying to avoid cutting yet another inspection port into the boat. I do have another question though, I've seen that gel coat repair video, and at one point it says that the top layer of gelcoat...
  12. S

    fiberglass repair on hull

    Wayne, posting a wider photo of the hull, I've done a little more sanding. Can't see the holes through the inspection port. thanks, Sue
  13. S

    fiberglass repair on hull

    Finally took some photos of the problem. I've got these two holes, next to each other. There are still some spider cracks I need to sand down, and a friend has suggested I just make it one big repair. That gray area is either a former repair, or the edge of the cockpit. The photos from...
  14. S

    fiberglass repair on hull

    "flex" might not be the right word, but there is certainly a lot of "give" when I press down on the hull, on both sides of the boat. Just worried that if part of the repair actually hits the bottom of the cockpit and part of it doesn't, it would crack again.
  15. S

    fiberglass repair on hull

    Finally have the sunfish dried out and ready to attempt repairs. Found two holes in the hull, both of them seem to start at the edge of the cockpit, and spread out from there. Looks like there is plenty of room between the outside of the hull and foam block, except for where it butts up against...
Top