Buy or borrow a moisture detector , they cost about 50.00 on Amazon. Run it over the transom ,hull and deck note the readings. If there are other J 24's in your area or at your club you can use these to create a baseline. It not unusual to have some moisture in these areas.The question is what...
I do not have a picture of my set up. But mine is a 2:1 setup. I have a microblock shackled to the BS at the split , before the bridle. I have a nylon snap end attached to top of bridle assembly led through block and tied off on pulpit.
I have tied a few engines over the past few seasons. The boat came eith a 4 hp johnson , great power to weight ratio but too unreliable. Then a i tried a couple of tohatsu 4 strokes 4 hp and 6hp same motor diferent carbs. It was reliable but very heavy. Not so much being stored below but when...
I put 4 coats of interprotect 2000 ,it is an epoxy barrier coat that is essential for any boat that is left in the water. A barrier coat creates a barrier that inhibits osmosis of salt water through the factory gelcoat into the core. Which is how a boat can gain weight. I then went with Petit...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.