Recent content by lasersailer148085

  1. lasersailer148085

    Major Repairs

    here are some pictures of the build. putting in only two flanges at a time due to shortage in clamps. its cold here in baltimore so i have the lamps covered in tin foil to try and keep the heat up also attached is a picture of the fibre glass i am using
  2. lasersailer148085

    Major Repairs

    Ya, I thought about that with my original repair. I really think that will help with getting it water tight and really bond the old and the new. Im using epoxy with filler to fill in the small gap between the patch and the old deck, should i then sand and put the fibreglass over that, or should...
  3. lasersailer148085

    Major Repairs

    So your saying, put in flanges under the deck, then sand at the seam of the deck, and put cloth down at the seam.
  4. lasersailer148085

    Major Repairs

    and im located in baltimore maryland
  5. lasersailer148085

    Major Repairs

    The foam on my boat is less then half inch and the lay up i did last time for the starboard side came out as the exact same thickness as the original. Also they use very soft foam. sorry for taking so long to respond but here is a picture of what the lay up looks like now that it is cured and...
  6. lasersailer148085

    Major Repairs

    im using west system epoxy and flanges that are going to be glassed in. I have a large amount of glass and i believe 1/4 inch dense foam
  7. lasersailer148085

    Major Repairs

    Sigh, so between not sailing a laser during the jr sailing season next year and all the sailing money going into the 505 i have had the job of fixing my laser yet again to make it semi race worthy. Any tips tricks and suggestions and good old conversation about my repairs would be fantastic. The...
  8. lasersailer148085

    Ever wonder why seitech wheels never come in the mail?

    Well i just got the scoop on seitech.... They are owned by laser performance.. if anybody knew that. I ordered a pair of class A dolly wheels on june 19. Still havn't gotten them. I called Laser today and found out im number 57 out of 112... so much for having them this summer. I called APS to...
  9. lasersailer148085

    Homemade Tiller

    is there any way to use a plastic tiller end and fit it onto a hockey stick?
  10. lasersailer148085

    Restoring Laser - couple questions

    About your decks. I junior race 148085 ( a 1992 hull) and this boat has been taken great care of but has been raced hard its entire life. So naturally the decks where going soft. I finally sucked it up and fixed the decks. My method seemed to have worked perfect as my decks are now are good as...
  11. lasersailer148085

    NEW BLOCKS

    so the two boom blocks?
  12. lasersailer148085

    NEW BLOCKS

    If you had to get one of the new blocks, instead of shelling out all $98 what would be the best block to buy
  13. lasersailer148085

    Boat leaking

    there should be a "O" shaped piece of rubber in between the drain plug and the drain plug fitting so when you screw it in it makes a seal
  14. lasersailer148085

    Replacing block plate on an old laser

    i had to replace the fitting this year. I drilled 1/2 inch holes and filled them back with epoxy-filler, and cover it with tin foil to prevent the epoxy from sinking

Back
Top