Evan,
good question...
The mast step was already separated. The daggerboard trunk was separated by using an exacto knife and separating the trunk from the deck...as i recall this took alot of work. Once i was able to get a larger flat tool into the gap i was able to pry the two apart...I...
I would agree with you that epoxy would work better if the hull and deck are not completely separated as in my case. In fact if i had to do it again i would likely use west 105/106 with a filler. The 5200 is very messy to work with. I am not disappointed with the results of using the 5200. 5200...
I found a 1978 laser for free....a tree fell on it. Hull and Deck separated along with hull cracks and holes. I've been working on it this past winter. i'm almost done. When i get a chance i'll completely document the fix...I completely separated the deck and hull, repaired all the cracks and...
I found a 1978 laser....a tree fell on it. Hull and Deck separated along with hull cracks and holes. I've been working on it this past winter. i'm almost done. When i get a chance i'll completely document the fix...In the mean time the following link has pictures of the repair. Probably not race...
I found a 1978 laser for free....a tree fell on it. Hull and Deck separated along with hull cracks and holes. I've been working on it this past winter. i'm almost done. When i get a chance i'll completely document the fix...In the mean time the following link has pictures of the repair. Probably...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.