Valid solution: Rapid set Marinetex
cheepest solution: Plumbers putty
also quick: a little silicon
proper solution: grind open, plug with epoxy paste, cure, sand, paint.
all solutions, clean well with isopropyl alcohol before applying solution.
I'm not likely to build one of these any time soon....
but
I'd love to know the details of your process and what do you plan next?
Wings perhaps...
Maybe you've created a new class, "Flying Lasers"
Yes,
I've done a section at a time,
The front section of floor I've done all at once, both sides,
The syringe I use comes from Composite Canada in Mississauga Ontario.
"Disposable Syringe with Catheter Tip 100ml"
Here is a shot of the stern deck with holes spaced 4 inches, laser II.
After the epoxy cured I dremmeled out a divot and patched that with epoxy with microballoons
This filled in the divot and gave me something to sand and make a smooth deck surface.
It's now solid as expected, bow deck also...
Hi Mark,
I drilled 1/8 inch holes through the first layer of glass, every 4 inches in an offset grid.
I injected epoxy with a turkey baster type of syringe into each hole, then tapped small mylar circles over the holes.
Then I turned on my hairdryer to apply pressure from the inside outwards.
I...
Hi mderry,
I'm doing the same repair to my laser II. I've done the decks , now for the floor.
Do your homework and you can fix it yourself.
Search for deck repair, or de-lamination,
films on Youtube.
Best of luck.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.