Trim piece needed

Discussion in 'Capri/Catalina 14 Talk' started by Cousin01, May 24, 2010.

  1. Cousin01

    Cousin01 New Member

    Likes Received:
    0
    Trophy Points:
    0
    I need the trim piece that sits above the cuddy, just aft of the mast step bracket. Mine is made of fiberglass. Older models used wood.
     

    Attached Files:

  2. chemprof

    chemprof Member

    Likes Received:
    8
    Trophy Points:
    18
    ...hmmm, the Mod 3 doesn't have this.

    It looks pretty flat, so perhaps you could get a strip of thin aluminum sheeting from Home Depot and cut it to fit. Aluminum can be easily cut on a table saw; just use a cheap blade with 40 or more teeth (10" diam).
     
  3. RC14A

    RC14A Member

    Likes Received:
    1
    Trophy Points:
    16
    The beauty of Fiberglass (and wood) is that it can be repaired . Lay the piece on a flat surface covered with wax paper , build up the damaged areas with epoxy and fiberglass strips to the desired thickness, trim , sand , fill , and paint and your good to go

    Good luck!

    Rob
     
  4. xiexie9981

    xiexie9981 Banned

    Likes Received:
    0
    Trophy Points:
    0
    Good job, well done.

    Good job, well done. Thank for your share!Cosplay Costumes
     

Share This Page