Removing outhaul sheave?

Discussion in 'J/24 Talk' started by StuJ, Oct 15, 2013.

  1. StuJ

    StuJ New Member

    Likes Received:
    0
    Trophy Points:
    1
    My outhaul sheave (wire sheave in center of outboard boom assembly) is frozen up. I've tried PB Blaster on it, but no luck. Is it possible to drive out the axle from the casting? If so, should I drive it to port or starboard? Will a hammer and pin-drift work, or will it take a press?
    Thanks,

    Stu
    J/24 #2822 "Vang Go"
     

Share This Page