Hairline crack in centerboard, time to replace?

Discussion in 'Capri/Catalina 14 Talk' started by caprintx, Jul 17, 2017 at 1:15 AM.

  1. caprintx

    caprintx New Member

    Likes Received:
    0
    Trophy Points:
    1
    Hello sailors. I'm the proud third owner of mod 1 Capri 14.2 hull #880. The boat has been very well kept, but one thing I missed when inspecting the boat was a hairline crack in the centerboard (CB). After two outings, the crack has become much more pronounced.

    Looking for advice on whether or not to replace the CB ($500 via Catalina Direct)? Or should I attempt to repair with epoxy and fiberglass cloth?

    As is, I am imagining the boat capsizing someday and pulling on the CB to right the boat only to have the CB break completely off.

    Thanks for any and all advice.
     

    Attached Files:

  2. woodbark

    woodbark Member

    Likes Received:
    2
    Trophy Points:
    18
    Sure looks like the result of some rough capsize recovery operations. Based on the cost of a new replacement; repair seems like a viable option and probably a good opportunity to beef up that area with some carbon fiber cloth instead of fiber glass. The important thing is to not overload the cloth with the Epoxy.
    Just my 2 cents worth. Cheers!
     
  3. caprintx

    caprintx New Member

    Likes Received:
    0
    Trophy Points:
    1
    Thanks for the advice. Is the centerboard removed by simply unscrewing the four screws on the stainless pivot plate? I'm guessing they're screwed into wood under the deck? Or are they machine screws with bolts? Should I expect to encounter marine adhesive holding the stainless plate in place?

    Thanks again!
     
  4. Al W

    Al W Member

    Likes Received:
    5
    Trophy Points:
    8
    Should not encounter too much adhesive though you never know what people did over the years. Take the four out and the plates should come right off. Good news is no center board truck so it can come out into the boat instead of out the bottom.
    Note the space on both side of the slot. You can't make repairs to the center board that make it wider. You must grind it down and repair ending up with the same thickness.
     
    • Agree Agree x 1

Share This Page