Gudgeon bracket for sunfish- need used or measurements to make it

Discussion in 'Sunfish Wanted Ads' started by Drew M., Aug 5, 2010.

Thread Status:
Not open for further replies.
  1. Drew M.

    Drew M. New Member

    Likes Received:
    0
    Trophy Points:
    0
    I could use your help. I am changing over the rudder on my 1971 Sunfish to the newer style used on post-1971 boats like yours. Unfortunately, the stainless steel transom bracket that holds the rudder pivot pin (#85011) is unavailable from dealers and on back order by the manufacturer, so I am looking for a used bracket or to make my own.

    I need its measurements. I would really appreciate knowing the bracket's width, height, and distance of each pivot hole to the hull. Thanks.
     
  2. maskry

    maskry New Member

    Likes Received:
    0
    Trophy Points:
    0
    Hi Drew,

    If you're willing to pay for shipping and willing to wait until after the 15th, I'll be happy to send you the bracket taken off a 1973 Sunfish. Email me your address at maskry@earthlink.net.
     
Thread Status:
Not open for further replies.

Share This Page