Search results

I use a Torqueedo electric motor. The removable battery is built into the motor so no wires or mounting required. It has more than enough juice to get you where you need to go with it without wind.

You asked about launching depth. My trailer has an extension pole that I pull out when launching. This gives me 8-10 feet of additional distance without getting my car wet.

Thanks for the comment. I really wanted the blue hull and although they refused to do it, the factory finally broke down and agreed. Not sure if they have done it since, so I might have the only one out there. Overall, I love this boat. It is exactly what I was looking for. Fun, yet stable...

should I oversize the boomkicker just to be sure? I have a keel version 14.2 and it sits on a mooring all week long. I like everything nice and tight to prevent wear and tear.

does the Boomkicker really hold up the boom, even while the boat is on the mooring?

mushroom anchors work on muddy bottoms. for hard bottoms use a concrete block. 150 pounds will be fine if the area is at all protected. if totally open to the wind, use 300 pounds. use chain (double the length of the depth of water) to connect the boat to the anchor. use rope to attach the chain...

I'm starting to wonder if the transom is NOT hollow. I saw that the motor mounts are through bolted in the area that I'm thinking of using. Maybe there's some "beef" there to hold a screw? the area of the transom designed to hold the motor mount is reinforced at the factory. the rest of the...

If you reverse the brackets both of the motor clamps might be half on steel and half on the motor mount. In my case, one motor clamp is half on, half off, while the other is fully flat on the mount.

I also have the standard factory motor mount but I ordered it with two right brackets so I could offset it away from the rudder by a few extra inches. this has worked for me there is no contact. see photos hopefully attached.

my mast has a hole with a cotter pin to do the same job.

I'm using a Torqeedo electric motor with standard length shaft on a factory installed motor mount. It works well except it drags in the water slightly when titled up under sail. Obviously it would be preferable if you could avoid this.

Looks to me like it is there to prevent the main sail from coming out of the mast.

id like to upload some photos of my new 14.2 keel boat but the files seem to be too big. can someone tell me how to compress them so they'll post?

From what I have been told, the trailing edge of the jib has a special UV treatment right on it. Nonetheless, I ordered a job cover with my new boat...more to prevent against whipping.

This is great stuff! I hope I plan to duplicate your effort. We're did you get the rubber mast supports from?

i'm ordering a new 14.2 keel version but can't seem to get good info on the trailer. does anybody have any photos, or comments regarding mast support, etc? what do i need to ask for now to avoid extra expense later?

great advice and great pictures to support it. i am using your solution on a new 14.2 keel i am buying right now.

wow. thanks for doing all this research. i will give Perry a call tomorrow.

do you have a knowledgable contact at the pickering dealership who could answer my questions and sell me the boat?

my plan is to buy the keel version. all i need is somewhere to buy one. doesnt seem like catalina has a dealer in quebec.