Search results

ok you loop it over the "vang tang" but what does it tie to on the deck? the only thing I have there is the fairlead for the Cunningham and two lines will not fit through it. Do I need to install another fairlead? or will that be against some rule? -- also, would that not inhibit the mast from...

Deck off? I never said to pull the deck off.... mine was not that bad see, so I only had to open it where the hull deck joint was already opening, and leaking. Ive never heard of anyone pulling the whole deck off, cause, ya, the mast step is also attached and the dagger board trunk. So just try...

well, Im going to be replacing some... probably ALL of the cleats so I guess a couple of deck mounted eyes should do the trick.... Its not against any rule is it?

Anyone ever had a mast fall out after a capsize? aparently the only thing holding the mast in, is the cunningham attached to the tack of the sail. does anyone use anything else? I was thinking maybe something that doesnt have to use the sail to hold the mast in - cause, if you are going downwind...

its funny that you should mention this 3 years later.. Heres what WILL work... you open the gap, grind out debris with high speed disk to get to bare F Glass. blow it out with air hose if you have one, if not use a brush to remove shavings. Mix up some 2 part epoxy, pour it in, let the gap...

I rigged up a 4:1 block and tackle system and hung'em high & dry till the spring tide rises (Rrr). this way it doesn't take block our cars from being in the garage and the laser doesn't have to stay outside all winter. heres some pics... 1st, storage on the car.. next, storage in...

ah never mind here it is http://www.boatbuilding.net/article.pl?sid=05/10/25/1437240 M/

Hi I noticed a bubble in my deck. At first I was going to open it up with a grinder, fill it and close it. but someone told me about a product that will "displace" any moisture and dry solid - apparently its injectable saving lots of time. but do you think I can find the product? NADDA! I...

custom bailer? the picture in post #12 by Alex L shows a tube in the hull - is that an after market bailer? are such custom bailers permitted in Laser class? cause the stock bailer doesn't seem to work M/

I was also planning at least one inspection port this winter. first, do you think there is more stress on the deck say, 1/2 way between the board and the mast offset to one side? OR I saw one dude cut into the cockpit on the angular part next to the board? OR can I put to in on the deck P&S...