Grab rail size

Just found one of my reserve plastic grabrails downstairs:
max total length: 99,2 cm
breadth (horizontal): 2,2 cm
hight (vertical): at the side to the cockpit wall: 2,o cm to 2,3* cm (*:where a screw-hole is)
at the side to the cockpit: 2,8 cm.
5 screw holes are to drill ( each is of diameter 0,5 cm): One in the symetry middle. From "that middle center point" of the bar (at 49,6 cm from the end of the bars) away to the ends: one hole at 22,25 cm and one at 44,5 cm.
Hope that helps.
LooserLu
 
Just found one of my reserve plastic grabrails downstairs:
max total length: 99,2 cm
breadth (horizontal): 2,2 cm
hight (vertical): at the side to the cockpit wall: 2,o cm to 2,3* cm (*:where a screw-hole is)
at the side to the cockpit: 2,8 cm.
5 screw holes are to drill ( each is of diameter 0,5 cm): One in the symetry middle. From "that middle center point" of the bar (at 49,6 cm from the end of the bars) away to the ends: one hole at 22,25 cm and one at 44,5 cm.
Hope that helps.
LooserLu
Thanks for the measurements, I will get the rails built early next week. Racing starts June 5.
 

Back
Top