These particular toggles are not stainless, although you can get them that way. They are supposed to be very corrosion resistant. They are designed for hollow wall applications and are quite strong. All other parts are stainless.
http://www.toggler.com/products/snaptoggle/overview.php
I need to repaint the bottom of a sunfish. It will be sanded and prepared well. I am leaning toward Rustoleum Topside. The boat is stored out of the water during the season, but is exposed to sun and on some days is in the water for 5-6 hours being sailed. Rustoleum Topside label says "Use...
The next step is to slide the plastic collar down as far as it will go and break off the long tails. The collar won't snug up because the fiberglass isn't thick enough. No worries. Now, insert the bolt thru the strap and then thru a stainless steel fender washer. Screw the bolt into the...
The next step is very important. Depending on where the foam is on your boat, you need to make sure it does not interfere with the toggle. I had to take a nail, cut the head off, bend a 90 degree angle and use a pair of vice grips tI had to drill on four boats, half required some clearing...
Well, a year later and I'm finally getting around to installing the hiking straps. All 4 of them :D ! I used a masthead hiking strap kit from intensity sails: http://www.intensitysails.com/mahistfakitf.htm In the front of the cockpit I used an inspection port to install the hardware. This...
I am starting to fix up an incredibly good condition used fish I picked up last fall. The only real issue is shown in the attached photo. If this was a white hull, I'd fill with marine tex and call it good, but since it is red that would look horrible. What are your suggestions for patching in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.