Hey Signal Charlie - how much of the Pettit EZPoxy2 would you expect to pour out to put a single coat on a hull? I'm really hoping that you can tell me specifically, like 8 oz paint, 2 oz activator, and 1 oz thinner. I don't want to overestimate and waste paint.
Thanks!
I have put off painting with the EZPoxy due to the heat. I live in Birmingham, AL, and it's expected to reach 94 today. I've read online (and on the EZPoxy directions) that 90 is the maximum temp limit to use this paint (some online forums even recommended that you not paint unless the temp's...
Two coats of primer on the hull. Should it be concerned that I used one quart of primer for the hull? Should I be thinning this stuff out?
I start with the EZPoxy on the hull tomorrow. Unless someone says that I should get some thinner.
Nothing like a little late afternoon sun to show you just how bad of a job you did fairing your hull. :(
Plus, I have more bubbles that are appearing under the gelcoat that I have to sand out. And I was just about to start painting the hull, too.
But, some progress has been made. I...
Made my first two blind patches today. The first one went well, though I might have used a bit too much resin. The second was a disaster. I put it in and tightened up the string. A little while later I thought it was fine so I took the tension off the string and went to go clean sone stuff up...
Ill prime and paint the hull later. In a few months maybe. Just flipped her over to start working on the deck. I've removed all of the hardware and am trying to remove the splash guard but there are five bolts the spin free but won't come out.
Any suggestions on how to remove them?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.