Recent content by c14_Greg

Good info Thanks for the good information. I went ahead and purchased a CDI furling system because it does allow for partial furling and it was recommended by the local sail maker. It seems pretty straight forward, although it does require a jib modification. I am hoping to have it all...

I have found a number of discussions in this forum regarding jib roller furling and the potential benefits to the single-hander. I have read them with great interest because I single-hand exclusively, and they have convinced me that it is time for me to try a furler. If I am seeing this right...

I was talking with an old salt down at the yacht club over the summer, and he was telling me about replacing various hardware on a used boat that he recently acquired. Part of the process involved replacing screws in the mast, boom, etc., by drilling out the holes, tapping new threads, and...

It seems to work for me too Very impressive pictures! I like the clean design. Much prettier than mine. I haven't gone so far at to tip my boat over on purpose yet, but I did watch the Bob bounce off the surface of the water one day after a strong gust pushed me over. I was able to...

The Baby Bob is magic I installed a Baby Bob earlier this spring after a turtling in 40 degree water that left me shivering for days afterward. The thing is magic -- I say that because I have managed to keep the boat upright with each outing since then. I used two pieces of 2-inch-wide...

I got a new one Hello again Richard, I didn't hear back from you about your used CB, so I decided to try Catalina directly. They made me one that fits (just put it in today) for $315, and they assured me that it is designed to be stronger than the original. I will definitely need that...

Hello, I need a new centerboard for my 1984 vintage Capri 14.2. I have tried a centerboard made by Catalina, but it is too wide to fit. Is there another source for these things, maybe from an aftermarket supplier? Thanks.